Stress-Strain Curves
The stress-strain curve visualizes how a material behaves under load, showing the relationship between applied stress and resulting strain.
Regions of the Curve
1. Linear Elastic Region
- Stress proportional to strain (Hooke's Law)
- Strain is reversible
- Slope = Young's Modulus (E)
- Ends at proportional limit
2. Nonlinear Elastic Region
- Slight deviation from linearity
- Still reversible
- Ends at yield point
3. Plastic Region
- Permanent deformation occurs
- Strain increases faster than stress
- Ends at ultimate tensile strength
4. Necking
- Localized reduction in cross-section
- Stress drops on engineering curve
- Ends at fracture
Key Points
| Point | Description |
|---|---|
| P | Proportional limit — linear relationship ends |
| Y | Yield point — plastic deformation begins |
| U | Ultimate strength — maximum stress |
| F | Fracture — material breaks |
Engineering vs. True Stress
Engineering Stress
Uses original cross-sectional area.
True Stress
Uses instantaneous area.
Relationship
Ductile vs. Brittle
Ductile Materials (e.g., Steel, Aluminum)
- Significant plastic deformation
- Well-defined yield point
- Necking before fracture
-
20% elongation
Brittle Materials (e.g., Cast iron, Ceramic)
- Little to no plastic deformation
- Fracture at yield
- No necking
- <5% elongation
Strain Hardening
After yielding, additional load causes the material to become stronger.
- K = Strength coefficient
- n = Strain hardening exponent
| Material | n |
|---|---|
| Aluminum | 0.15 |
| Copper | 0.54 |
| Steel | 0.20 |
Effect of Temperature
- Higher temperature → lower E, lower yield
- At elevated temperatures, creep becomes significant
- Cryogenic temperatures → higher strength, lower ductility